| The following pictures and instructions will assist you in setting up and running your very own IONIC SILVER GENERATOR USE ONLY QUALITY PURE SILVER AND ONLY DISTILLED WATER. |
| ONCE AGAIN I CAN NOT EMPHASIZE ENOUGH. USE ONLY DISTILLED WATER USE ONLY PURE 99.99% SILVER NO SUBSTITUTIONS. |
| You will need a new jar. 2 quarts is used in this demo. |
| Pure Silver Wire at least 99.99% pure |
| Distilled Water |
Under construction :
please watch your step and watch for workman on site
please watch your step and watch for workman on site
| Step 1 Measure jar from top to bottom This one is 6 inches |
| Step 2 Measure off 2 peices of wire the same lengths as the jar is from top to bottom. Here it is two 6 inch wires. |
| Step 3 Form a 1 inch hook at one end of each wire |
| 2 wires should look something like this. |
| Placed the hooked wires into the jar. Let the hook loop over the jar lip. The wires should not be touching the bottom of the jar. There should be 1 inch from the bottom of the jar to the end of the wire. |
| Step 4 |
| Step 4 |
| Distilled Water only. Do NOT use tap or bottled waters. DISTILLED WATER ONLY |
| Step 5 Hook up leads to Silver wire. Polarity does not matter. |
| STEP 5 |
| STEP 5 |
| Step 6 Pour in the water |
| Step 6 |
| Keep water level at or below the shoulder areas of the jar. |
| Step 7 Turn on power supply set to 30 VDC. You will show no current flowing on current meter. |
| Step 8 Cover the jar with plastic I am using a large plastic bag |
| Step 7 |
| Keep trash out of your Ionic Solution. Secure the bag by placing the jar lid on top of the plastic. |
| Step 6 |
| Let the Power supply run at 30 VDC for 10 hours. If you have done everything correctly you will have an Ionic Silver solution at 10 to 15 ppm. Turn off the power supply after 10 hours and let the solution sit for 12 to 24 hours. At the end of 12 to 24 hours you may notice that the solution is not clear but somewhat tinted. Next see the filtering and storage link |
| Typical Silver concentration in PPM per time period. 6 hours (6) for 2 quarts size will yield approximately = 4 ppm per volume 9 hours (9) for 2 quarts size will yield approximately = 9 ppm per volume 10 hours (10) for 2 quarts size will yield approximately 10 ppm per volume This is a rule of thumb for amounts of 1quart up to 1 gallon volume preparation of Ionic Silver. Regardless of volume or container type, Filter the solution into a new clean Dark Blue Bottle. Other colors will work but Silver plating has been seen to occur on most with in months of storage. |